mspa Mont Blanc Manual Del Usuario página 14

7.4 Replace the air valve cap (c) back on the control panel. Close and recess the inflation valve (a)
NOTE: Deflation Instruction
Spa Deflation
1. Unscrew the air valve cap on the spa pool to deflate the spa.
2. Once the deflation is completed, replace the cap back.
Spa Bladder Deflation
1. Pull the valve cap out and squeeze the valve at its base until deflated.
2. Close and recess the valve back.
8.
Water Filling
8.1 Check the spa liner is at the selected area and
point the drain valve toward a suitable draining
area before inflation.
8.2 Fill the spa tub with fresh water to a level between
Minimum and Maximum line marked on the
inside of the spa wall.
Do not over fill the spa. It is recommended to fill the
spa with lukewarm water for quick heating and energy saving.
WARNING:
●
Water level must reach the Minimum water line but not exceed the Maximum line to
avoid pump failure.
●
Never pour water with a temperature higher than 40°C(104°F) into the spa directly.
●
To avoid control system failure, do not operate the spa until water reaches the Minimum
line.
8.3 After water filling, double check the spa pool air pressure to make sure the manometer points out
the Green section.
8.4 Place the inflated air bladder and the zipper spa cover over the spa tub, and make sure the spa
cover zipper are closed and lock the cover by the digital lock in the accessory pack.
IMPORTANT:
● Inspect the spa pressure regularly for leak, premature wear or deterioration.
● Check and wax the zipper regularly, to make it smooth for operation and avoid splits.
8.4
8.5 Turn on the Heater on the spa control panel, refer to the "Control Panel Operation" section.
Maximum heating temperature is 42°C(108°F). Hourly heating rate is about 1.5°C-2°C(2.5°F-3.5°F)
for 4 persons and 1.2°C-1.8°C(2°F-3°F) for 6 persons.
8
14