Rain Bird ESP Guía De Instalación, Funcionamiento Y Programación página 56

CONTROLS AND SWITCHES
The illustration to the right shows the controls, switches, and indicators on the ESP
Modular controller, including:
1. LCD – during normal operation, displays the time of day; during programming, shows 1
the results of your commands; during watering, shows the valve that is watering and
the minutes remaining in its run time.
2. Alarm LED – turns on when one of the following conditions occurs: 2
• Watering is suspended by a sensor
• The controller senses a valve short circuit
• A programming error has been made
3. Up-Down, ON-OFF Buttons — used to adjust program settings up or down, or turn 3
watering days ON or OFF.
4. Manual Start / Advance Button — 4
(Advance) is used to sequence through programming steps or set values.
5. Program Slide Switch — used to select watering program A, B, or C.
5
6. Sensor Bypass Switch —used to tell the controller to obey (
6
input from an optional sensor.
7. Programming Dial — used to turn the controller off and on, and for programming. 7
Rain Bird ESP Modular Controller
®
(Manual Start) is used to start an irrigation
program or station valve(s) manually.
) or ignore ( )
1 2
3 4 5 6 7
Installation, Programming and Operation Guide 55