www.weg.net
NOTE!
This symbol indicates that:
- At the end of its service life, the product must enter the recycling system.
- You should dispose of it separately at an appropriate collection point; do not dispose of
it with municipal solid waste.
- It is waste sorting of electric and electronic devices, and batteries.
- The horizontal bar below the garbage bin indicates the device was manufactured after
August 13, 2005.
NOTE!
The Gateway or components replaced by the Technical Assistance are collected by WEG and sent to
the respective suppliers for the correct disposal.
The whole device and its package are made of materials that can be recycled by specialized waste
sorting companies.
Information on the materials that compose the Gateway and its components can be viewed on:
www.weg.net/wegmotorscan
4. CERTIFICATIONS AND REGULATIONS
4.1. ANATEL APPROVAL
This device has no right to protection against harmful interference and cannot
cause interference in duly authorized systems.
06600-19-12464
To consult the ANATEL approval certificate, access the following address:
https://sistemas.anatel.gov.br/mosaico/sch/publicView/listarProdutosHomologados.xhtml
4.2. FCC REGULATIONS (US)
It contains FCC ID: 2ALGLX1000
This device has no right to protection against harmful interference and cannot cause interference in duly
authorized systems.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
NOTE!
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
For additional information, please go to:
https://www.cassianetworks.com
24
Gateway X1000
Figure 3.4 - Disposal symbol
4.3. IC REGULATIONS (CANADA)
It contains IC: 22505-X1000
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) I'appareil ne doit pas produire de
brouillage, et (2) I'utilisateur de I'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
NOTE!
For additional information, please go to:
https://www.cassianetworks.com
Pour obtenir de I'aide supplémentaire, rendez-vous sur: https://www.cassianetworks.com Cassia Networks, Inc.
4.4. RADIO EQUIPMENT DIRECTIVE (EU)
EU SIMPLIFIED DECLARATION OF CONFORMITY
Hereby, Cassia Networks Inc. declares that:
Bluetooth Router Radio Equipment CASSIA X1000 Series, conforms with:
Radio Equipment Directive 2014/53/EU;
Low Voltage Directive 2014/35/EU;
Electromagnetic Compatibility (EMC) Directive 2014/30/EU;
RoHS Directive 2011/65/EU and its addenda.
The full text of the EU Declaration of Conformity is available at the following website:
https://www.cassianetworks.com.
DANGER!
RF exposure warning:
This equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
www.weg.net
Cassia Networks, Inc.
Gateway X1000
25