Chip Extraction; Saw Blade Selection; Saw Blade Change; Riving Knife/Splitter - Mafell KSS 60 36B Manual De Instrucciones Original

Do not use force to do so.

4.4 Chip extraction

Danger
Substances that are harmful to
health must be taken up with an M-
suction device.
Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20
m/s (65.6 ft / sec.).
The inside diameter of hose connector 1 (Fig. 3) is 35
mm (1 3/8 in.).

4.5 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts especially along the grain in soft or hard
wood:
- Circular saw blade carbide Ø 185 x 1.8 x 20 mm,
16 teeth
For cuts especially across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 185 x 1.8 x 20 mm,
32 teeth

4.6 Saw blade change

Danger
Unplug the rechargeable battery for
all service work.

Remove the
automatically blocks the shaft.

Using the Allen key 4 (brackets Fig. 3) release
the flange screw 5 (Fig. 3) counter clockwise.
Remove the screw and the front clamping flange
6 (Fig. 3).

Now you can remove the saw blade after
opening the retractable saw guard.

The clamping flanges must be free of adhering
parts.
rechargeable battery.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

Refit the rechargeable battery.

4.7 Riving knife/splitter

The riving knife 7 (Fig. 3) prevents the saw blade
from jamming during longitudinal cutting. The correct
distance to the saw blade is shown in (Fig. 4).

For adjustment purposes, release the screw 8
(Fig. 3) with the Allen key 4 that is included in
the supply (Fig. 3).

Adjust the riving knife/splitter by moving it in its
longitudinal groove and retighten the screw
afterwards.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".

5.2 Switching on and off


Switching on: First press the lock-off button 9
(Fig. 2), then activate the switch trigger 10 (Fig.
2).

Switching off: For switching off, release the
switch trigger 10 (Fig. 2).
This

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 66 mm.
Proceed as follows to adjust it:

Unfasten the clamping lever 12 (Fig. 1).

Set the cutting depth with the plunge lever 13
(Fig. 1).
-23-
Danger
Unplug the rechargeable battery for
all service work.
to the chapter "Safety