Height Adjustment - TRAPP Super Turbo 1000 Manual De Instrucciones

www.trapp.com.br
Height and angle of adjustable handle
adjustmen
For greater ease and comfort while handling
 
the equipment the operator can adjust the
height and angle of the handle as described
and shown in the following drawing.

Height adjustment

1. Release the plastic nut (1) that fixesthe
adjustable handle support to the handle (2).
2. Slide the adjustable handle (3) upwards or
downwards to the desired height.
3. Tighten the plastic nut (1).
Angle adjustmen
1. Release the lever (4).
2. Adjust the handle as desired.
3. Tighten the lever (4).
Lever (4)
Manípulo (4)
Manípulo (4)
Height adjustment (extendable
handle) Super Turbo 1000
TRAPP Super Line is equipped with a system
 
that allows you to adjust the height of the
Lawn Mower/Trimmer for more comfort
during usage. To adjust the height of the Lawn
Mower/Trimmer, do as follows:
Disconnect female connector (1) from
O 
male connector (2), slide upper handle (3)
either upwards or downwards to adjust
height as appropriate.
1
1
1
Adjustable handle (3)
Punho ajustável (3)
Punho ajustável (3)
Plastic
Porca
net (1)
Porca
plástica (1)
plástica (1)
Handle (2)
Cabo (2) Cabo (2)
2 3
2 3
2 3
5
5
5
Replacement of the nylon line
The life of the nylon line depends on the skill
 
the operator has to avoid contact with stones,
walls, fences and sidewalks. Frequent contact
with those obstacles cause premature wear
out of the nylon line.
To substitute it, get a refill containing the
 
spool and the nylon line from TRAPP
technical assistance shop or from specialized
dealers.
How to remove and replacethe
spool
Make sure the equipment is unplugged.
 
Turn the equipment upwards.
 
Hold the spool base (6) with one hand and
 
with the other remove the spool cover (1)
turning it counterclockwise (as shown in the
spool cover).
After removing the spool (3), thoroughly
 
clean the equipment base, taking care not to
allow grass to fall in the motor compartment.
To replace the spool, pass the tip of the
 
nylon line (4) through hole (2), fit the spool
on cover (1), align the spool cover on the
base guide (5), press it downward and turn it
clockwise until you hear a "click".
1
1
1
3
3
3
7
7
7
6
6
6
Attention!
Whenever substituting the spool (refill),
keep the spring (7) to reuse it.
2
2
2
4
4
4
5
5
5
31