Ega Master 56066 Manual De Instrucciones página 18

Ranuradora manual
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

¡Note!
Pipe or tubing longer than the specified maximum lengths listed in Chart above must be sup-
ported with 2 pipe stands. The second pipe support should be located 3/4 of pipe length from roll
groover. Failure to use two stands may result in the unit tipping or the pipe falling.
1. Lift up on feed handle and place pipe on drive roll and pipe support.
2. Square pipe and pipe support to roll groover making sure pipe is flush against drive roll flange. (Fig
2)
3. Level pipe by adjusting pipe stand.
4. Slightly offset (approximately 1/2°) pipe and pipe stand toward operator when the power source
operates in REVERSE mode (Figure 3).
NOTE!
If power source runs in FORWARD offset pipe 1/2° away from operator. (Figure 4).
18
PIPE SET-UP
Fig. 2. Square the pipe and pipe support.
Fig.3. Operating the machine in
reverse direction.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

5606756030

Tabla de contenido