Installation Place - IKOS MONO Manual Del Usuario

Outside air intake
Model I2.A03

Installation place

The stove installation should be done by specialized technical.
Complying with national and regional security and installation standards and regulations.
When the stove is installed inside a house all exhaust gases pipes should be completely sealed.
Use a proper and approved pellet vent pipe with silicone sealing.
The stove should not be dragged over an unprotected floor.
If the floor is made from combustible materials, the installation place of the stove should be
protected with a non-combustible materials. It should also protect the area near the door
avoiding falling hot pellets. The stove should be installed in a floor with capacity to support its
weight, if this is not possible use a base to equally distribute the weight of the stove.
Respect the security distances to combustible materials as well as the necessary distances
for maintenance.
Place the stove considering the hot air outlet of the equipement providing the best distribution
of the heat to the room.
EN // 111
USER'S MANUAL
Outside air intake
Model I2.A02
EN