Loading And Unloading The Discs; Setting Your Printing Preferences - Rimage Producer 7100 Manual Del Usuario

Rimage Producer 7100™ and Producer 8100™ User Guide

Loading and unloading the discs

You can load up to 100 discs in a bin. You can either remove the carousel to load discs or use
the procedure below to place discs in each bin.
To load discs:
1. Open the front door.
2. To rotate the carousel and place a bin in
position to load discs, press the operator
button.
3. After removing all completed discs from
the bin, place up to 100 discs to be
recorded the bin.
Important! Place the discs with the
recording side facing down.
Tip: Bins 1 through 4 may be
specified as input, output, reject, or a
specific media type, depending on
how you configure your software.
4. Repeat steps 2 - 3 until the required bins are filled.
5. Close the front door.
To unload discs:
1. Open the front door.
2. To rotate the carousel and place a bin in position to remove discs, press the operator
button.
3. Remove the discs from the bin.
4. Repeat steps 2 - 3 until the required bins are empty.
5. Close the front door.

Setting your printing preferences

Printing preferences allow you to set up and run your Producer III autoloader to produce the best
possible label on your discs. Refer to your Everest Printer User Guide or PrismPlus! Printer User
Guide for specific printing preferences instructions.
8 110867_A