MIDI Implementado
❍General Purpose Controller 7 (Controller number 82)
Status
2nd byte
BnH
52H
n = MIDI channel number:
vv = Control value:
❍General Purpose Controller 8 (Controller number 83)
Status
2nd byte
BnH
53H
n = MIDI channel number:
vv = Control value:
❍Portamento control (Controller number 84)
Status
2nd byte
BnH
54H
n = MIDI channel number:
kk = source note number:
GProgram Change
Status
2nd byte
CnH
ppH
n = MIDI channel number:
pp = Program number:
* These messages are transmitted when Patch, Rhythm Set or Performance is selected. But
not transmitted when Transmit Program Change parameter (SYSTEM/MIDI) is OFF.
* In Performance mode, these messages are not transmitted when External PC Num
parameter (PERFORMANCE/PART) is OFF.
GChannel Pressure
Status
2nd byte
DnH
vvH
n = MIDI channel number:
vv = Channel Pressure:
GPitch Bend Change
Status
2nd byte
EnH
llH
n = MIDI channel number:
mm, ll = Pitch Bend value:
IChannel Mode Messages
GMONO (Controller number 126)
Status
2nd byte
BnH
7EH
n = MIDI channel number:
mm = mono number:
GPOLY (Controller number 127)
Status
2nd byte
BnH
7FH
n = MIDI channel number: 0H - FH (ch.1 - 16)
ISystem Realtime Messages
GActive Sensing
Status
FEH
* This message is transmitted at intervals of approximately 250 msec.
* This message is not sent when Transmit Active Sensing parameter (SYSTEM/MIDI) is
OFF.
218
3rd byte
vvH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
3rd byte
vvH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
3rd byte
kkH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
0H - FH (ch.1 - 16)
00H - 7FH (prog.1 - prog.128)
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
3rd byte
mmH
0H - FH (ch.1 - 16)
00 00H - 40 00H - 7F 7FH (-8192 - 0 - +8191)
3rd byte
mmH
0H - FH (ch.1 - 16)
00H - 10H (0 - 16)
3rd byte
00H
ISystem Exclusive Messages
Universal Non-realtime System Exclusive Message" and Data Set 1 (DT1) are the only
System Exclusive messages transmitted by the JUNO-G.
GUniversal Non-realtime System Exclusive Message
❍Identity Reply Message (JUNO-G)
Receiving Identity Request Message (p. 213), the JUNO-G send this message.
Status
Data byte
F0H
7EH, dev, 06H, 02H, 41H, 6BH, 01H,
02H, 01H, 04H, 03H, 00H, 00H
Byte
Explanation
F0H
Exclusive status
7EH
ID number (Universal Non-realtime Message)
dev
Device ID (dev: 10H - 1FH)
06H
Sub ID#1 (General Information)
02H
Sub ID#2 (Identity Reply)
41H
ID number (Roland)
6BH 01H
Device family code
02H 01H
Device family number code
04H 03H 00H 00H
Software revision level
F7H
EOX (End of Exclusive)
GData Transmission
❍Data set 1 (DT1)
Status
Data byte
F0H
41H, dev, 00H, 00H, 15H,12H, aaH, bbH, F7H
ccH, ddH, eeH, ... ffH, sum
Byte
Explanation
F0H
Exclusive status
41H
ID number (Roland)
dev
Device ID (dev: 00H - 1FH, 7FH)
00H
Model ID #1 (JUNO-G)
00H
Model ID #2 (JUNO-G)
15H
Model ID #3 (JUNO-G)
12H
Command ID (DT1)
aaH
Address MSB: upper byte of the starting address of the data to be sent
bbH
Address:
upper middle byte of the starting address of the data to be sent
ccH
Address:
lower middle byte of the starting address of the data to be sent
ddH
Address LSB:
lower byte of the starting address of the data to be sent.
eeH
Data:
the actual data to be sent. Multiple bytes of data are transmitted
in order starting from the address.
:
:
ffH
Data
sum
Checksum
F7H
EOX (End Of Exclusive)
* The amount of data that can be transmitted at one time depends on the type of data, and
data will be transmitted from the specified starting address and size. Refer to the address
and size given in Parameter Address Map (p. 222).
* Data larger than 256 bytes will be divided into packets of 256 bytes or less, and each
packet will be sent at an interval of about 20 ms.
Status
F7H
Status