Air Conditioner Parts Description; Installation Of The Indoor Unit - McQuay CE-C Serie Manual De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Indoor Unit

Air Discharge Louver

Air Discharge Grille

Air Intake Grille

Air Filters

(Inside Air Intake Grille)

Fig. A

Preliminary Site Survey

•

Electrical supply and installation shall conform to the local

authority (e.g. National Electrical Board).

•

Voltage supply fluctuation must not exceed ±10% of the rated

voltage. Electricity supply lines must be independent of weld-

ing transformers which can cause high supply fluctuation.

•

Ensure that the installation location is convenient for wiring

and piping.

Standard Mounting

Ensure that the overhead supports are strong enough to hold the

weight of the unit. Position the hanger rods (wall

mounting bracket for floor standing), and check for its

alignment with the unit. Also, check that the hangers are secured

and the base of the fan coil unit is leveled in both horizontal direc-

tions, taking into account the gradient for drainage flow as recom-

mended in Figure B.

400mm (Min.)

Please ensure that the following steps are taken:

•

Check the gradient for drainage flow as recommended in Figure B.

•

Provide clearance for easy servicing and optimal air flow as

shown in Figure C.

•

The indoor unit must be installed such that there is no short

circuit of the cool discharge air with the warm return air.

•

Do not install the indoor unit where there is direct

sunlight shining on the unit. The location should be

suitable for piping and drainage installation. The unit must be

a large distance away from the door.