SATA jet 1000 A RP/HVLP Instrucciones De Servicio página 108

Operating Instructions SATA Automatic Gun
EN
gun body [13-1] using a screwdriver
[13-3]. Secure with Loctite 242.
■ Position the nozzle head [11-7] on the
gun body [11-6].
■ Tighten the four cheese-head screws
[11-8] crosswise.
■ Insert the paint needle [11-5].
■ Position both springs [11-3], [11-4].
■ Screw on the end cap [11-2].
■ Screw on the regulating cap [11-1].
■ Adjust the material flow if necessary
(see chapter 9.2).
10.4. Replacing spindles of
round/flat fan control
The procedure is the same for both
spindles.
Dismantle spindle
■ Unscrew the countersunk screw
[14-3].
■ Remove the control knob [14-2].
■ Unscrew the spindle [14-1] using the
SATA universal spanner.
Mount new spindle
■ Screw the spindle [14-1] in using the
SATA universal spanner.
■ Position the control knob [14-2].
■ Screw the countersunk screw [14-3]
by hand. Secure with Loctite 242.
108
10.5. Replacing the control
piston components
Attention!
If the seal or sleeve of the control
piston is damaged, it is possible
for air to leak from the material
flow control
[1-4]
lating cap .
[1-2]
→ Replace seal or sleeve imme-
diately.
The sealing surface of the control
piston is very sensitive and dam-
ages easily.
→ Do not chuck the control piston
at the sealing surface.
Dismantle components
■ Unscrew the regulating cap [15-1].
■ Unscrew the end cap [15-2].
■ Remove both springs [15-3], [15-4].
■ Remove paint needle [15-5].
■ Pull the control piston [15-6] out using
flat pliers.
■ Fix the control piston [16-7] using the
SATA universal spanner.
■ Unscrew hex socket screw (spanner
size 4) [16-9].
■ Remove O-ring [16-8].
■ Unscrew banjo screw (spanner size
14) [16-1].
■ Remove washer [16-2] and sleeve
[16-3].
■ Take the compression spring [16-4],
washer [16-5] and seal [16-6] out of
the control piston.
■ Check parts for damage and soiling,
clean or replace if necessary.
Mount new components
■ Fix the control piston [16-7] using the
or from the regu-