Overview Of The Components; Packaging Contents; Unpacking The Device; Notes On Use - Profi Cook PC-WKS 1107 G Instrucciones De Servicio

• This appliance is used for heating and boiling water. Never use to
heat up other fluids or foodstuffs.
• Only use the appliance in a dry, indoor area. It is intended for do-
mestic use and similar areas of use such as e.g.
- In staff kitchens in shops, offices and other commercial areas;
- By guests in hotels, motels and other accommodation facilities.
It is not intended for use in farm accommodation or Bed & Breakfast
establishments.
• The following symbols are on the product:
CAUTION:
Do not immerse the device into water for cleaning. Please follow
the instructions as stipulated in the chapter "Cleaning".

Overview of the Components

1 Spout
2 Contact area for closing the lid
3 Lid
4 Button for opening the lid
5 Handle
6 Water level indicator
7 On / Off switch
8 Base

Packaging Contents

1x Water kettle
1x Base

Unpacking the Device

1. Remove the device from its packaging.
2. Remove all packaging materials such as films,
padding, cable holders, and cardboard.
3. Check the packaging contents for completeness.
4. Check the device for any transport damage in order
to avoid hazards.
NOTE:
If there is any visible transport damage, contact your
dealer immediately. Do not operate the device if
damaged!
PC-WKS1107G_IM

Notes on Use

Preparation
Before using for the first time, boil fresh water at least
three times in the appliance. Use only water without
any additives or ingredients.
Mains Lead
Completely unwind the length of mains lead that you
require from the bottom section of the base. Please
ensure that the mains lead does not become tangled
up.
Electrical Connection
Check whether the electrical voltage that you intend to
use is the same as that of the appliance. Details are to
be found on the label on the base.
Connected Wattage
The total power consumption of this device can be up
to 2200 W. With this connected load a separate supply
line protected by a 16 A household circuit breaker is
recommended.
CAUTION: Overload!
• If you use extension leads, these should have a
cable cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this device is
too powerful.
35
05.04.16