Step 2: Connect The Power Cord; Step 3: Turn On The Monitor And Computer; If No Picture Appears On Your Screen - Sony Trinitron CPD-E400E Manual De Instrucciones

Step 2: Connect the power cord

With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
AC IN
to AC IN
to a power outlet
power cord (supplied)
(HD15)
1
Step 3: Turn on the monitor and
computer
First turn on the monitor, then turn on the computer.
The installation of your monitor is complete.
If necessary, use the monitor's controls to adjust the picture.

If no picture appears on your screen

• Check that the monitor is correctly connected to the computer.
• If NO INPUT SIGNAL appears on the screen, confirm that the
video signal cable is properly connected and all plugs are firmly
seated in their sockets.
• If MONITOR IS IN POWER SAVE MODE appeared on the
screen, try pressing any key on the computer keyboard.
• If you are replacing an old monitor with this model and OUT
OF SCAN RANGE appears on the screen, reconnect the old
monitor. Then adjust the computer's graphic board so that the
horizontal frequency is between 30 – 96 kHz, and the vertical
frequency is between 48 – 120 Hz.
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 16.
Setup on various OS (Operating System)
This monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information with the Windows
Plug & Play function. No specific driver needs to be installed to the
computer.
If you connect the monitor to your PC, and then boot your PC for the first
time, the setup Wizard may be displayed on the screen. Click on "Next"
several times according to the instructions from the Wizard until the Plug
& Play Monitor is automatically selected so that you can use this monitor.
If your PC/graphics board has difficulty communicating with this
monitor, load the supplied Setup Disk. Refer to the "Read Me" file on the
Disk about the procedure to install. You can also download the
information by accessing the web site of the graphics board's
manufacturer.
For customers using Windows NT4.0
Monitor setup in Windows NT4.0 does not use the display driver. Refer
to the Windows NT4.0 instruction manual for further details on adjusting
the resolution, refresh rate, and number of colors.
GB
7