Metrohm 756 KF Instrucciones Para El Uso página 98

4.2 Remote control commands
90
$G starts the 'FILL' mode of the connected Dosino.
4.2.2.84. Assembly.Bur.ModeDis
Assembly.Bur.ModeDis.Selected
Assembly.Bur.ModeDis.V
Assembly.Bur.ModeDis.Time
Assembly.Bur.ModeDis.VStop
Assembly.Bur.ModeDis.AutoFill
Dispensing mode for the connected Dosino. The dispensing mode can only be
started and stopped via the RS Control. During a running dosification, no method can
be started at the Coulometer.
.Selected: Dispensing of volume increments or during a preset time.
.Volume, .Time: Size of the volume increments or entry of time.
.VStop: Limit volume for the dispensing.
.AutoFill: ON means automatic filling after every dispensing.
4.2.2.85. Setup.Comport
Selects the Coulometer COM for the output of automatic info:
&Setup.Keycode
&Setup.Trace
&Setup.SendMeas
&Setup.AutoInfo
4.2.2.86. Setup.Keycode
ON means the key code of a key pressed on the Coulometer is outputted. The key
code comprises 2 ASCII characters; table of the keys with their code, see page 96. A
keystroke of key 11 is sent as follows:
#11
The beginning of the message is marked by a space (ASCII 32).
4.2.2.87. Setup.Tree.Short
Setup.Tree.ChangedOnly
Definition of the type of answer to $Q.
.Short: With "ON", each path is sent with only the necessary amount of charac-
ters in order to be unequivocal (printed in bold in this manual). A combi-
nation of .Short and .ChangedOnly is not possible.
.ChangedOnly: Sends only the changed values, i.e. values which have been edited.
All paths are sent absolute, i.e. from the root.
4.2.2.88. Setup.Trace
The Coulometer automatically reports when a value has been confirmed with
<ENTER> at the Coulometer. Message, e.g.:
&SmplData.OFFSilo.Id1"Trace"
The beginning of the message is marked by a space (ASCII 32).
4.2.2.89. Setup.Lock.Keyboard
$G, $S, $H, $C
volume, time
0.0001...0.1...9999
0.25...1...86400
0.0001...9999, OFF
ON, OFF
1, 2, 1&2
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
756/831 KF Coulometer, Instructions for Use