Before Using; Charging Your Speaker - Furrion FBS012NVP-BL Guía De Inicio Rápido Y Manual Del Usuario

Installation
Hand Strap Installation
Tie the end of the hand strap, with thin cord, to the metal ring on the
speaker. Wrap the other end around your wrist. (Fig. I and Fig. J)
Fig. I
8
Fig. J

Before Using

Charging your Speaker

Before using the speaker, you must charge the device for a minimum of
5 hours using Micro USB Charing Port or 3.5 hours (minimum) using the
charging base. You may check the power level by short pressing the
button before operating your speaker each time. The power indicator will
be illuminated in white for 3 seconds to show the current power level and
then disappear.
5 Light: 80%-100%
–
4 Light: 60%-80%
–
3 Light: 40%-60%
–
2 Light: 20%-40%
–
1 Light: 0-20%
–
It is recommended you fully charge the battery before using for the first
time. The speaker can be charged in three ways:
● If a genuine Furrion charging base is installed, place the speaker
into the charging base to charge. The speaker will be fully charged in
approximately 3.5 hours.
● Lift to open the rubber cap at the end of the speaker. Connect one end
of the adapter to the Micro USB Port on the speaker and the other end
to a 5V DC outlet. The speaker will be fully charged in approximately
5 hours.