Snapper XD SXDUC82 Manual Del Propietário página 4

SAFETY INFORMATION
• Do not operate in explosive atmospheres such as in the presence of flammable liquids, gasses or flammable dust. If in
doubt, wait for dust to settle before using.
• Be sure the area is clear of other people before moving. Do not allow children, bystanders, or pets in your work area when
your utility cart is being moved.
• Remove or disconnect battery before servicing or cleaning.
• Use only the following type and size battery(ies): BSB2AH82 (2 amp-hour) or BSB4AH82 (4 amp-hour) or BSB5AH82 (5
amp-hour) and Briggs & Stratton charger BSRC82 or BSSC82.
• Do not dispose of the battery(ies) in a fire. The cell may explode. Check with local codes for possible special disposal
instructions.
• Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause damage to the eyes or skin. It may
be toxic if swallowed.
• Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and
keys. The battery or conductor may overheat and cause burns.
• Dress Properly - Do not wear loose clothing or jewelry. They can be caught in moving parts. Use of rubber gloves and
substantial footwear is recommended when working outdoors. Wear protective hair covering to contain long hair.
• Use Safety Glasses .
• Don't Force Appliance - It will do the job better and with less likelihood of a risk of injury at the rate for which it was designed.
• Store Idle Appliance Indoors - When not in use, appliances should be stored indoors in dry, and lockedup place - out of
reach of children.
• Check Damaged Parts -Before further use of the appliance, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other
part that is damaged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in
this manual.
• Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected
situations.
• Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A
careless action can cause severe injury within a fraction of a second.
• Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in unexpected situations.
• For safety, battery only can be used at -14~4℃ for discharge, and 6~40℃ for charge.
• The charging voltage must be less than 84V.
• The charging current of BSB5AH82 (5 amp-hour) must be less than 30A. The charging current of BSB4AH82 (4 amp-
hour) must be less than 30A. The charging current of BSB2AH82 (2 amp-hour) must be less than 30A.
• For battery tools:
• Instructions regarding battery charging, information regarding ambient temperature range for tool and battery use and
storage, and the recommended ambient temperature range for the charging system during charging;
• For a battery-operated tool intended for use with a detachable battery pack or a separable battery pack: instructions
indicating the appropriate battery packs for use, such as by a catalog number, series identification or the equivalent;
• Instructions indicating the appropriate charger for use, such as by a catalog number, series identification or the
equivalent.
• NOTE In Europe (EN 62841-1), the following additional requirement applies: for battery tools with integral battery:
• Do not expose a battery pack or tool to fire or excessive temperature.
• Follow all charging instructions and do not charge the battery pack or tool outside the temperature range specified in the
instructions
• Do not use the power tool if the switch does not turn it on and off.
4