Use - SATA minijet 3000 B HVLP Instrucciones De Servicio

Operating Instructions SATAminijet 3000 B HVLP, minijet 3000 B T HVLP
• Do not use solvents and cleaning agents based on halogenised
hydrocarbons! Chemical reaction which may occur when using these
substances may be explosive!
7.

Use

• Use only solvent-resistant, antistatic, undamaged and technically flaw-
less compressed air hoses with a permanent pressure resistance of
minimum 10 bar / 145 psi, e.g. Art. No. 53090!
The following requirements must be fulfilled:
• Use of a compressed air connection G 1/4 male thread or of a fitting
SATA connection nipple.
• Ensure minimum compressed air volume (air consumption) and pres-
sure (recommended spray gun inlet pressure) according to chapter 2.
• Use clean compressed air, e.g. by installing the SATA filter 484, Art.
No. 92320
• Use an air hose with minimum 9 mm inner diameter (see warnings),
e.g. Art. No. 53090.
Check if all screws [2-1], [2-2], [2-3], [2-4] and [2-5] have been
176.
tightened firmly. Tighten fluid tip [2-1] firmly by hand (max. 12 Nm)
according to [7-4]. Check if locking screw [2-5] has been firmly tight-
ened according to [10-1]. Tighten, if necessary.
177. Rinse material passages with suitable cleaning solution [2-6], ob-
serve chapter 8.
Adjust air cap: vertical spray fan [2-7], horizontal spray fan [2-8].
178.
179. Attach gravity cup [2-9].
180. Fill gravity cup (max. 20 mm below upper edge), close with the lid [2-
10] and insert anti-drip device [2-11].
181. Screw connection nipple [2-13] (not included in delivery) onto the air
inlet.
Warning! Risk of explosion!
Warning! Risk of explosion!
Information!
US
407