Operating And Display Elements; Operation - Dometic 972 Serie, 976 Serie Instrucciones De Uso

Operation

5.1

Operating and display elements

No. in fig. 1,
page 2
1
2
3
4
5
6
7
8
6 Operation
6.1 Setting up the portable toilet
NOTE
I
Changes in the ambient temperature or the actual height above sea
level while travelling can cause the pressure in the holding tank to
rise or fall.
Before use, make sure that the pressure in the holding tank is
equalised by opening and closing the slide valve with the seat cov-
er closed.
➤ Before use, make sure the pressure in the holding tank is equalised:
to do this, open the slide valve with the seat cover closed by pulling the
flush grip out and then pushing it closed it again (fig. 2, page 2).
➤ Remove the cap of the flush water tank and fill it up until the water level
has reached approx. 25 mm (1 inch) below the top. Screw the cap on
again on the flush water tank (fig. 3, page 2).
➤ Pull the flush grip to open the slide valve (fig. 4, page 2).
➤ Put an appropriate sanitary additive directly into the holding tank.
➤ Close the slide valve (fig. 5, page 2).
8
Description
Pump
Cap for flush water tank
Flush water tank
Holding tank
Filling level display
Flush grip
Locking grip
Flush button
972, 976
EN