Publicidad
SETUP
For best results, fully charge controller and power bank prior to first use.
CHARGING CONTROLLER + POWER BANK
• Using the included 6.5ft (2 m) USB Cable, connect the Micro-USB end to lower port at top of the
controller, and connect the Standard USB end to any powered USB source.
• When charging, four LEDs will display the charging level from 25-50-75-100%.
CHARGE LEVEL INDICATOR
Check battery charge level by pressing the battery status button ( ) on front lower left of controller.
The LEDs will indicate the current charge level from 25-100% even when controller is off.
WIRELESS MODE
Move Wireless/Wired switch on front center of controller to BT (
wireless mode.
• If controller is off, press the MENU button ( ) to turn on (LED will illuminate).
• Press and hold the Bluetooth sync button ( ) on back of controller for 2 seconds to enter pairing
mode (LED will flash rapidly).
• Enter the Bluetooth settings on your device and choose the MOGA controller. The pairing LED will turn
solid when connected.
NOTE: A previously paired device will automatically pair to the controller when powered on.
POWERING OFF
Hold the menu button ( ) for 5 seconds to turn controller off and save battery capacity.
WIRED MODE
Move Wireless/Wired switch on front center of controller to USB (
• Connect Micro-USB end of the 7.8" (20 cm) or 6.5ft (2 m) cable to lower port at top of controller, and
connect other end to your gaming device.
• Gaming device input ports (Standard USB, Micro-USB, USB-C) will determine whether you use shorter
or longer micro-USB cable for wired gaming.
GAMING CLIP
A detachable gaming clip is included for use with gaming on your phone. You can use USB cables with
clip attached for charging or wired mode.
1. Slide MOGA Controller into gaming clip by tipping top edge in first.
2. Push controller bottom edge down into clip until it locks into notch on front edge of controller.
3. To insert phone, push top edge of phone against top of phone grip to expand upward.
4. Push bottom of phone down flat into place as you reach top limit of phone grip.
5. Adjust phone horizontally to center alignment over controller, and adjust viewing angle forward or back.
6. Open kickstand on clip when setting controller down between sessions to prevent tipping.
7. Remove clip by pulling front edge forward to release from notch.
INTEGRATED POWER BANK
) which indicates Bluetooth
A Power Bank built into the controller allows you to charge your phone during gameplay or while
controller is off.
• Connect Standard USB end of the 11.8" (30 cm) cable to upper port at top of controller, and connect
other end to your mobile device.
• During gameplay, move the Power Bank switch below right thumbstick to the right (on) to start
charging. If you prefer to use battery power to extend controller usage time rather than charge
phone, move swith to the left (off).
• To charge mobile device when controller is not in use, simply connect cable between controller and
device to begin charging (Power Bank Switch must be ON).
• Your mobile device will display charge status once connected. If charging does not begin, the power
bank battery may be too low: recharge controller.
• The amount of charge available for your phone depends on how much battery capacity remains on the
) which indicates wired mode.
controller when charging begins.
ASSIGNING THE ADVANCED GAMING BUTTONS
1. Press the Orange Program Button on the bottom of the controller for 2 seconds. The LED Connection
Indicator will flash, signaling the controller is in assign mode.
Publicidad
