Storing The Machine; Checking And Replacing Chain Sprocket - Stihl MS 290 Manual De Instrucciones

Storing the Machine

For periods of about 3 months or longer:
:
Drain and clean the fuel tank in a
well ventilated area.
:
Run engine until carburetor is dry,
this helps prevent the carburetor
diaphragms sticking together.
: Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
:
Thoroughly clean the unit,
pay special attention to the cylinder
fins and air filter.
:
If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
:
Store the unit in a dry and high or
locked location, out of the reach of
children and other unauthorized
persons.
MS 290, 310, 390
Checking and Replacing
Chain Sprocket
: Remove the chain sprocket cover,
chain and guide bar.
: Disengage the chain brake:
Pull hand guard toward the front
handle.
– Replace the chain sprocket after
using two Oilomatic chains.
– Replace sooner if the wear marks
on the sprocket are deeper than
approx. 0.02 in (0,5 mm) since this
would reduce the life of the chain.
You can use a gauge ("Special
Accessories") to check the depth of
the wear marks on sprockets.
It is best to use two chains in
rotation with one sprocket.
Use only original STIHL chain sprockets
to ensure correct operation of the chain
brake.
English / USA
5
6
2
1
4
3
6
: Use a screwdriver to remove
the E-clip (1).
: Take off the washer (2) and rim
sprocket (3).
:
Examine splines on clutch drum (4)
– if wear marks are severe, fit a new
clutch drum.
:
Pull clutch drum or spur sprocket
(5) and needle cage (6) off the
crankshaft.
2
1
47