Auxiliary Handle; Switching On And Off - Toolland TM82006 Manual Del Usuario

5. Overview
Refer to the illustrations on page 2 of this manual.
1 on-off switch
2 locking switch
3 forward-reverse lever
4 hammer/drill switch
5

auxiliary handle

6. Operation
6.1 Auxiliary Handle
The auxiliary handle can be mounted on the left or the right side of the chuck. Mount the handle at the flange
behind the chuck and fix it by turning the grip of the handle clockwise in the desired position.
Depending on the working method, the auxiliary handle can be adjusted in different positions.
This device should be used with both hands only! Do not use the device if the
6.2 Inserting a Drill Bit
Accessories can be very hot after use. Do not touch them with bare hands!
Inserting
1. Open the chuck (with the key if necessary).
2. Insert the drill bit correctly into the chuck. Make sure the drill bit is not inserted skew.
3. Close the chuck, first by hand and then tightly with the key.
Removing
1. Open the chuck with the key.
2. Remove the drill bit from the chuck.
6.3 Depth Gauge
1. Slightly loosen the auxiliary handle and insert the depth gauge into the intended hole.
2. Move the depth gauge until the distance between the tips of the drill bit and the depth gauge corresponds
to the required drilling depth.
3. Tighten the auxiliary handle firmly.
6.4

Switching On and Off

Keep the on-off switch pressed to start the device and to operate. Release to switch it off. Note that the
rotation speed can be varied by applying more or less pressure on the on-off switch.
Use the locking switch if desired:
1. Press the on-off switch and then press the locking switch.
2. Release the on-off switch.
3. Press the on-off switch again to release.
Also, determine the maximum rotation speed with the speed control knob on the on-off switch.
6.5 Forward/Reverse Drilling
1. Make sure to release the on-off switch and that the drill bit has come to a full stop.
2. Slide the forward-reverse lever to the forward/reverse position.
3. Press the on-off switch again to use the impact driver.
V. 01 – 07/07/2016
TM82006
WARNING
auxiliary handle is missing or damaged.
WARNING
5
6 chuck
7 depth gauge
8 maximum speed control knob
9 key
©Velleman nv