JVC HR-J4006UM Manual De Instrucciones página 57

1
1 2
4 5
7 8
SP/EP
0
••
3
OK
3
2
6
9
NUMBER "9"
4
TIMER
••
SET TAPE SPEED
7
Press SP/EP to set the tape speed.
RETURN TO NORMAL
SCREEN
8
Press PROG. or OK. "PROGRAM COMPLETED"
appears on the screen for about 5 seconds, then normal
screen appears.
ENGAGE TIMER MODE
9
Press TIMER. The VCR turns off automatically and "‰"
is displayed on the display panel.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key "9") for weekly serials or DAILY (NUMBER key "8") for daily
serials (Monday–Friday). Either "WEEKLY" or "DAILY" appears
on the screen. Pressing the button again makes the correspond-
ing indication disappear.
NOTES:
To disengage the timer before recording starts, press TIMER
again. Pressing once more re-engages it.
In case of a power failure after programming, the VCR's memory
backup keeps your selections for approximately 10 minutes.
Programs that start after midnight must have the next day's date.
After timer recording is completed, the VCR's power goes off
automatically.
You can program the timer while a regular recording is in
progress; the on-screen menu will not be recorded.
If the end of tape is reached during timer recording, the
cassette is automatically ejected.
When timer-recording cable or satellite channels through an
external tuner, be sure to keep the cable box or satellite
receiver's power ON.
ATTENTION
If there is a conflict in the timer schedule and one program
overlaps with another, only the parts shown below in gray
will be recorded.
Pattern 1: The program with the lower program number
will be recorded.
10:00 11:00
Program 1
CH10
Program 2
CH40
Pattern 2: The program that is broadcast earlier will be
recorded.
10:00 11:00
Program 1
CH10
Program 2
CH40
Pattern 3: The program that is broadcast earlier will be
recorded, followed by the remaining portion of
the other program.
10:00 11:00
Program 1
CH10
Program 2
EN
12:00
Not recorded
12:00
Not recorded
12:00
CH40
Not recorded
23