Resumen de contenidos para Kimberly Clark Professional JACKSON WH10 Serie
- Página 1 HaloX Series WH10 Passive Welding Helmet Masque de soudeur passif 900 Series Casco para soldar pasivo HSL Series User Instructions Instructions d'utilisation Instrucciones de uso...
- Página 2 WARNING! TO AVOID BLINDNESS, PERMANENT EYE INJURY OR VISION LOSS, ALWAYS: WEAR chalumeau dans le filtre auto-obscurcissant. Utilisez toujours un filtre dont l’intensité est adaptée au travail de IMPACT-RESISTANT SAFETY SPECTACLES OR GOGGLES WITH THIS HELMET AND/OR FILTER. USE THE soudage à...
- Página 3 WH10 HSL100 / HaloX Operating Instructions / Consignes d'utilisation / Instrucciones de uso The JACKSON SAFETY* Brand WH10 HSL100/HaloX Welding Helmet is shipped fully assembled with a Shade 10 Filter plate and safety lenses properly inserted. Replacing Safety Lenses: 1. Remove the complete filter assembly from the helmet by squeezing in the side tabs on the wire retainer and lifting the wire retainer at the base, releasing it from the engagement notches on both sides.
- Página 4 WH10 HSL2 Operating Instructions / Consignes d'utilisation / Instrucciones de uso Replacing Safety Lenses: 1. Lift the flap on the front of the helmet. 2. Release the retaining spring by pressing down on the top of the spring, then pull the spring down.
- Página 5 WH10 951P Operating Instructions / Consignes d'utilisation / Instrucciones de uso The JACKSON SAFETY* Brand WH10 951P Welding Helmet is shipped fully assembled with a Shade 10 Filter plate and safety lenses properly inserted. Replacing Safety Lenses: 1. Remove the complete filter assembly from the helmet by pushing up on the bottom tabs on the wire retainer and lifting the wire retainer at the base, releasing it from the engagement notches.
- Página 6 WH10 930P Operating Instructions / Consignes d'utilisation / Instrucciones de uso The JACKSON SAFETY* Brand WH10 930P Welding Helmet is shipped fully assembled with a Shade 10 Filter plate and safety lenses properly inserted. Replacing Safety Lenses: 1. Lift the flap on the front of the helmet. 2. Release the retaining spring by pulling down on the notch at the top of the spring, then pull the spring down.