Rear Camera Input; Sound Settings; Volume Distribution (Fader/Balance); Equalizer - Suzuki San Pedro 800 Manual De Instrucciones

Sound settings | Basic settings

Rear Camera input

This device features a video input at the rear of the device
for connecting a camera that is available as an option. If
a rear camera is connected, the image is displayed on the
screen, when the rear gear is engaged.

Sound settings

Volume distribution (fader/balance)

You can adjust the volume distribution in the vehicle
for all sources.
In the main menu or on the control bar of the current
audio source, press the [
The equalizer menu is displayed.
Press the [ ] button.
The menu for fader and balance is displayed.
Adjust fader and balance with [
[ ] / [ ].
Next, press [ ].
The setting is stored, the current source is displayed
again.

Equalizer

You can adjust the equalizer for all sources.
In the main menu or on the control bar of the current
audio source, press the [
The equalizer menu is displayed.
Select a preset equalizer via the buttons.
- Or -
12
] button.
] / [ ] or
] button.
Press the [ User ] button to adjust the level of
the available frequency bands according to your
preferences.
Note:
With the [ Reset ] button, you can reset the
customised setting again.
- Or -
Press the [ Flat ] button for a linear sound playback.
Press the [ Loudness ] button to switch increasing
the bass at low volume on or off.
Next, press [ ].
The setting is stored, the current source is displayed
again.

Basic settings

In the settings menu, you can adjust the basic settings for
the different functions of the device to your requirements.
In the main menu, press the [ Settings ] button.
The settings menu is displayed, the General submenu
is activated.
Call up the submenus with the buttons in the lower
area of the settings menu.

General

The following settings are possible:
Radio region – Select the reception region for the radio
reception.
FM HICUT - Trun on the function to enhance the signal
of FM.
Blackout – If this value is set, the display of the radio is
completely switched off after 10 or 20 sec. without use.
Dimmer mode – Adjust the display brightness
Beep – Switch confirmation beep on/off
TFT calibration – The touchscreen can be calibrated
here.
Software version - Show the version of software
Load factory settings - Resets all personalised settings.
Rear view camera - normal/mirror