FALMEC Piano Manual De Instrucciones página 49

pening, use low-temperature washes (55°C max.).
To extract the metal anti-grease filter, remove the part with the adjust-
able flaps from the suction unit (see the instructions
1 2
- (Fig. - ) and lift the filter by the handle (Fig.
We recommend you clean the drilled part (B)(Fig.
of the suction unit (Fig. at the same time
damp cloth slightly moistened with neutral liquid or washing up liquid.
Do not use corrosive, acid or alkaline detergents.
Finish of cleaning by rinsing off well and wait for the parts to be com-
pletely dry before reassembling them.
Reposition the drilled part and the metal anti-grease filter by following,
in reverse order, the operations described in Fig.
GREASE DRIP TRAY
The grease drip tray collects the oil and grease
that are deposited on the metal anti-grease
filters.
The metal filters retain the grease and oil
thanks to their inclination and by being heat-
ed when fired and let them flow into the tray
positioned beneath the suction unit near the
lower part of the filters. It is advisable to emp-
ty the tray at constant intervals depending
on the use (approximately every 15 days) and wash it with boiling
water and washing up liquid.
Do not use corrosive, acid or alkaline detergents.
Rinse it well and wait for it to be completely dry before reassembling it.
Remove the grease drip tray by accessing the bottom of the suction
unit (see the instructions Q on page 33 - (Fig.
the tray has horizontal as possible when removing it (Fig.
UNDER FURNITURE CARBON-ZEO FILTER UNIT KIT (OPTIONAL)
Carbon-zeo filters have the function of retaining odours in the air flow
passing through them. The air, purified by running many times through
the filter, is recirculated into the kitchen.
The combination of coal and zeolite provides greater filtering capacity
and contributes with absorption of part of the steam generated during
cooking.
The carbon-zeo filters do not require special maintenance. Under nor-
mal conditions, we recommend restoring them every 18 months
and replacing them every 3 years.
For maintenance of the carbon-zeo filters, extract the Piano under fur-
niture carbon-zeo filter kit from its housing which, in standard installa-
tions, is behind the kitchen plinth.
Remove the plinth (see the instructions
unhook the set (AF) from the part (FK) connected to the suction pipe:
the two parts are joined by magnets, therefore simply pull gently as
2
shown in (Fig. ).
Unscrew the 5 screws (V5) (Fig.
5
) and extract the carbon-zeo filters (Fig.
To restore them, place them into a normal domestic over at 200° for
about 2 hours.
Wait for the filters to cool before reassembling them; put them back in
their seat, reassemble the metal cover (A) by following, in reverse order,
the operations described in (Fig.
on the part (FK), ensuring that the joined magnets are correctly sealed.
Lastly, reposition the previously removed kitchen plinth.
Q on page 33
3
).
5
) and the inside
4
): use boiling water and a
3
.
3
): be careful to keep
6
).
R on page 34 - Fig.
3 4
- ) remove the metal cover (A) (Fig.
6
).
5
) and carefully reinstall the set (AF)
DISPOSAL AFTER END OF USEFUL LIFE
The crossed-out wheeled bin symbol on the appliance means that the
product is WEEE, i.e. "waste electrical and electronic equipment", ac-
cordingly it must not be thrown out with unsorted waste (i.e. with
"mixed household waste"), but it must be disposed of separately so that
it can undergo specific operations for its re-use, or a specific treatment,
to remove and safely dispose of any substances that may be harmful to
the environment and remove the raw materials that can be recycled.
Correct disposal of this product contributes to saving precious resourc-
es and avoiding potential negative effects on human health and the en-
vironment, which could be caused by inappropriate waste disposal. You
are kindly asked to contact your local authorities for further information
regarding the designated waste collection points nearest to you. Penal-
ties for improper disposal of such waste can be applied in compliance
with national regulations.
INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES
The EU WEEE Directive was implemented differently in each country,
accordingly, if you wish to dispose of this appliance we suggest contact-
ing your local authorities or dealer to find out what the correct method
of disposal is.
INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUN-
TRIES
The crossed-out wheeled bin symbol is only valid in the European
Union: if you wish to dispose of this appliance in other countries, we
suggest contacting your local authorities or dealer to find out what the
correct method of disposal is.
1
) and
49