Safety Regulations - LEM HEME ISO 1000 Instrucciones De Uso

Safety Regulations

1. Safety Regulations
• Safety warnings and precautions must be read and understood before the
instrument is used. They must be observed during use. Operating
electrical devices implies that parts of the device carry dangerous
voltages. Disregarding warning notices may lead to serious physical
injury and material damage. For example: touching the key tips.
•
This measuring device is only to be installed and operated by qualified
personnel and according to the technical data in compliance with the safety
precautions and regulations set forth below. Additionally, the use of this
equipment requires compliance with all legal and safety regulations pertaining
to each specific application. Similar regulations apply to the use of accessories.
•
Test leads, prods and crocodile clips must be in good order; clean, and with no
broken or cracked insulation
•
Replacement fuses must be of correct size, type and rating
•
It can be assumed that safe operation is no longer possible if the device
- shows visible damage,
- has been exposed to unfavourable conditions (e.g. storage beyond
the permissible climatic limits without adaptation to the ambient
climate, dewing etc.) or to
- has been exposed to major strain during transport (e.g. been dropped
from some height without visible external damage etc.).
• No measurements must be performed on unprotected measuring circuits.
•
Avoid working alone.
International Elecrical Symbols used on the instrument:
Caution! Refer to the instructions before using this instrument.
Equipment protected throughout by Double insulation (Protection Class II)
Equipment complies with relevant EU Directives
Dangerous voltage
COM Ground
Qualified Personnel are persons familiar with the setting up, installation, starting off
and operation of the device and possess a formal qualification required for such
activities.
- 4 -