Marsh Touch Taper 4BT Serie Manual Del Propietário página 64

Repair
Replacing the
Computer Board
Figure U
Figura U
25005/97231 Rev D
7. Slide the new plate under the tape channel.
8. Replace the eight screws on the brush tank plate.
9. Replace the brush tank and water regulator.
1. Turn the power switch off and unplug the power cord.
2. Remove the measuring head cover by removing the four head cover screws.
3. Lift the head cover to expose the connector plug and gently pull the plug up from
the computer board. See Figure U.
4. Remove the mounting screw on the computer board.
5. Gently lift and remove the old board and slide the new one into place.
6. Replace the mounting screw.
7. Plug the connector into the new board.
8. Replace the measuring head cover by inserting the four head cover screws.
Head Cover Screw
Vis du couvercle de la tête de mesure
Tornillo de la tapa del cabezal
Measuring Head Cover
Couvercle de la tête de mesure
Tapa del cabezal medidor
Fiche de connexion
Enchufe conector
Mounting Screw
Tornillo de montaje
Computer Board
Carte informatique
Tarjeta computadora
Connector Plug
Vis de fixation
63