Juice Extraction; After Using - Beem Multi-FiXX 500 Manual De Instrucciones

Multi-FiXX 500

Juice extraction

Place the jug (3) onto the motor unit
‹
(1) with the handle to the right and
turn the blender jug clockwise until it
audibly snaps in.
If the chopping blade (7) is fitted, re-
‹
move it from the spindle attachment
(4) by pressing in the latches.
WARNING
Danger from sharp blades!
► Do not touch the blades. Always hold
the chopping blade by the plastic
shaft.
If the grating disc (5) or the cutting/
‹
rasping disc (6) is fitted, remove it
from the spindle attachment (4).
Put the spindle attachment (4) onto
‹
the drive spindle of the jug (3).
Insert the drive attachment (11) into
‹
the collecting bowl (10) and lock it by
turning it clockwise.
Put the collecting bowl (10) onto the
‹
jug (3) and lock it by turning it clock-
wise.
NOTE
► Make sure that the jug (3) and the
collecting bowl (10) are seated prop-
erly, otherwise the appliance cannot
be operated (safety switch).
Place the grater attachment (12) onto
‹
the drive attachment (11).
26
Insert the plug into the mains socket
‹
and move the rotary switch (1) to im-
pulse or continuous operation level 1.
To extract juice, push the halved fruit
‹
onto the grater attachment (12).
CAUTION
► Observe the maximum operating
time of 2 minutes.
► Allow the appliance to cool down for
1 minute.
NOTE
► Pay attention to the maximum filling
quantity in the blender jug (3).
► In the case of larger quantities,
empty the collecting bowl periodically
to prevent overflowing.

After using

Switch off the appliance and pull the
‹
plug out of the mains socket.
Rinse the jug and the accessories
‹
used with water.
Clean the appliance and the accesso-
‹
ries used as described in the section
Cleaning and care.
BEEM - Elements of Lifestyle
EN