Device Overview - Cameo XNODE 4 Manual De Usuario

DEVICE OVERVIEW

1
3
2
5
4
7
6
6
OLED DISPLAY
1
ENCODER WHEEL / [OK] BUTTON
2
The encoder is primarily used for selecting menu items by turning the knob. It also functions as a push button. This manual refers to this
button simply as [OK] button or [OK].
[CANCEL] BUTTON
3
4 ETHERNET PORT BUTTON [E]
5 ETHERNET PORT
(RJ45 Neutrik etherCON socket)
PORT BUTTONS [1] – [4]
6
These push buttons are used to open the port menu of the corresponding port. A port status LED showing status information is located
directly below each of those buttons.
SIGNAL OUTPUT
7
and input ports 1 – 4.
1
8 NEUTRIK POWERCON INPUT SOCKET
NEUTRIK POWERCON OUTPUT SOCKET
9
USB TYPE-B SOCKET
10
for firmware updates.
MAINS CONNECTION
The user must supply a suitable power cable. He may then either hard-wire the power cable to the building's electrical installation, provi-
ding an easily accessible power on/off switch close to the device, or install on the power cable a grounding-type (earthed) mains plug that
is suitable for the local power outlets, following the power plug manufacturer's instructions. Consult a qualified electrician, if you have any
doubts about the proper installation.
A blue Neutrik powerCON NAC3FCA cable mount connector must be used to supply power at the XNODE 4's power input socket.
• Input mode only available on devices produced after 2017 (hardware rev. 1.0-b)
1
7
7
6
7
6
8 9
10
5