Replacing Power Pack - Schluter Systems LIPROTEC LT EK 24V30W, LIPROTEC LT EK 24V50W Manual De Uso

Fault Cause of fault
Power pack
overloaded
Power pack
defective
Lighting Cable
flashes or connections are
flickers not firmly
tightened
Power pack
overloaded

10.2 Replacing power pack

If you think that the power pack has a fault, proceed as
follows:
Get a qualified electrician to check the power pack.

Get a qualified electrician to replace the faulty power

pack with a new one.
Directions for use for the power pack
Troubleshooting
Select a larger power pack
(up to max. 150 W)
Replace power pack (only by
qualified electrician).
Check the cable connections
for non-positive locking.
Select a larger power pack
(up to max. 150 W)
EN
Repair
59