digades dguard Instrucciones De Uso página 13

INSTALLING THE dguard
Observe the following requirements at the installation location:
• Ensure that the cable is long enough to reach the installation locations
of the vehicle components, the GPS antenna, the vehicle battery and
the positive terminal of the power circuit activated by the ignition.
• Choose a hidden installation location (and one that provides maximum
protection in the event of an accident) for the dguard
the motorbike frame (e.g. under the seat or in the rear of the frame).
• The dguard
not be fitted directly under the metal parts of the motorbike.
EN
1. Find a suitable place to install the module.
2. Lay the cable with the 16-pin connection X1 at the installation location
of the dguard
3. Lay the cable with the 3-pin connection X3 for the dguard
(Fig. 5/4)
4. Ensure that the cable of the GPS antenna
installation location of the GPS antenna to the installation location of
the dguard
p. 16).
5. Connect the black wire to the positive terminal of the power circuit
activated by the ignition
6. Ensure that the cables are not chafed by the frame, are not bent or
crushed and are not laid in the vicinity of hot components (such as the
exhaust or cylinders).
7. Connect the brown wire to the negative terminal of the vehicle battery
(FIg. 5/3).
8. Connect the red wire to the positive terminal of the vehicle battery
(Fig. 5/3).
9. Temporarily fix unconnected plugs to the planned installation location
of the vehicle components.
12
SYSTEM
®
module requires mobile phone reception and thus should
®
(Fig.
module
®
on the handlebar.
(Fig. 5/1) (Chapter „3.3 Installing the GPS antenna",
module
®
(Fig.
INFO
The 2-pin connection X4
ries. To guarantee protection class IP67, all plugs must be
connected and engaged fully. The vacant 2-pin connec-
tion X4 has a dummy plug that only needs to be removed
if you intend to attach accessories
5/1).
(Fig. 5/6)
5/2).
(Fig. 5/5)
is reserved for accesso-
module within
®
button
®
can reach from the