Installing The Dguard ® Module - digades dguard Instrucciones De Uso

Ocultar thumbs Ver también para dguard:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 129
INFO
When you first switch on the system, it may take up to 2
minutes until the LED goes out.
4. Clean the selected location for the adhesive pad
GPS antenna thoroughly and remove all residue of dust, moisture or
grease.
INSTRUCTION
The adhesive surfaces of the adhesive pad
be dry and free of dust and grease. Clean the adhesive
surfaces thoroughly before sticking.
5. Ensure that the adhesive surface of the adhesive pad
of impurities.
6. Stick the adhesive pad
7. Press the GPS antenna against the adhesive surface. Try to use the
entire surface of the adhesive pad.
Ö You have now installed the GPS antenna.
3.4 Installing the dguard
The dguard
module is the main interface for accident detection and theft
®
warning and is thus the heart of your dguard
ule contains the SIM chip required to place an emergency call.
Observe the following requirements at the installation location:
Choose a hidden location (and one that provides maximum protection
in the event of an accident) within the motorbike frame (e.g. under the
seat or in the rear of the frame).
INSTRUCTION
The dguard
thus should not be fitted directly under the metal parts of
the motorbike.
1. Clean the selected location thoroughly and remove all residue of dust,
moisture or grease.
INSTALLING THE dguard
(Fig. 4/2)
to the selected location.
module
®
module requires mobile phone reception and
®
(Fig. 4/2)
and the
(Fig. 4/2)
(Fig. 4/2)
system. The dguard
®
SYSTEM
®
EN
must
is free
mod-
®
17

Publicidad

Tabla de contenido
loading

Tabla de contenido