Maytronics Dolphin Hybrid RS 1 Instrucciones De Uso página 10

The following are typical problems that might occur and possible solutions.
Table 3: Troubleshooting
Symptom
The Cleaner does not move or moves slowly
(without indicator light)
The Cleaner moves on the back wheels only
The Cleaner moves on the front wheels only
The Cleaner gets stuck on the pool drain
The hose is twisted
The Cleaner is turning in circles
Air bubbles at the exit of the water from the
jets, or a noise of air suction
L
8
_book_8151171_Dolphin_Hybrid_v2.indb 8
Possible Solutions
• Correct insufficient flow. (Refer to Table 1).
• Remove the service opening cover on the Cleaner bottom
(Drawing L) and clean out any trapped debris (Drawing M).
• If a track slipped off the wheels, return it. If this occurs
frequently, purchase replacement tracks from your supplier.
• Contact your supplier for repair.
• Connect additional Hose Sections.
• Correct excessive flow. (Refer to Table 1).
• Make sure that the Float is in the correct position. (Refer to
"Connect the Cleaner" on page 5).
• Remove the Float from the last Hose Section.
• Make sure to stop operation of the pool drain while the
Cleaner is working.
1. Turn the pump OFF.
2. Remove the Cleaner from the pool.
3. Open the swivel and clean it (Drawing N).
4. Close the swivel properly and make sure the swivel moves freely.
• The suction is below MIN. (Refer to Table 1).
If does not help, contact your supplier.
1. Ensure that the hoses are firmly fastened.
2. Ensure that the Leaf Canister lid is firmly closed.
N
Dolphin Hybrid RS 1 - Suction Pool Cleaner
M
| Operating Instructions
17/6/2012 1:34 PM