Wilo Stratos GIGA Serie Instrucciones De Instalación Y Funcionamiento página 45

No. Designation
4.2.2.0 Consumption
4.2.3.0 Countdown, pump
cycling
4.2.4.0 Remaining time
until pump exercise
4.2.5.0 Mains on counter
4.2.6.0 Pump exercise
counter
4.3.0.0 States
4.3.1.0 Base-load pump
4.3.2.0 SSM
4.3.3.0 SBM
Installation and operating instructions Wilo-Stratos GIGA
Type Symbol Values/explanations
Energy consumption in
kWh/MWh
Time to pump cycling in h
(at a resolution of 0.1 h)
Time until the next pump exer-
cise (after the pump has had a 24
h standstill (e.g. via Ext. off), it
will be automatically operated
for 5 seconds)
Number of switching-on proce-
dures of the supply voltage
(each occasion the supply volt-
age is established after an inter-
ruption is counted)
Number of pump exercises car-
ried out
The value display statically
shows the identity of the regular
base-load pump.
The unit display statically shows
the identity of the temporary
regular base-load pump.
ON
State of the SSM relay if there is
no fault signal
OFF
State of the SSM relay if no fault
signal is present
ON
State of the SBM relay if a readi-
ness/operation or "mains on"
signal is present
OFF
State of the SBM relay if no read-
iness/operation or "mains on"
signal is present
Display conditions
Shown only for DP-MA and
internal pump cycling. Can
be set in the service menu
<5.1.3.0>
Only displayed in DP-MA
mode
39
English