Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
G
B
TO MOW: USING THE LAWNMOWER
WHEN TO MOW?
Preferably, mow the law when
the grass is dry.
Mow damp or tall grass first
with a high cutting height, then
mow again at the final height
required.
[40 mm] corresponds to the
optimum cutting height adjust-
ment.
ADJUSTING
THE CUTTING HEIGHT
Only make this adjust-
ment when the motor is
switched off and the blade
has stopped.
- Pull the adjustment lever
outwards (1-fig.9), turn it to
the cutting height required
(2-fig.9) and release it into
the new notch (3-fig.9).
The numerical values on the
indicator correspond to the
cutting height in millimetres.
Adjust
the
cutting
according to the mowing
conditions. If the grass to be
mown is very dense or wet,
the cutting height must be
raised.
FITTING THE GRASS BAG
Always carry out this
operation with the motor
switch off.
70
- Lift the safety shield/deflec-
tor and place the grass bag
chute in the ejection chan-
nel, then fasten the bag onto
the lawnmower frame by its
front hooks (fig. 10) and rest
the safety shield/deflector on
the top of the bag.
Before beginning to
mow, check the grass bag
and the safety shield/deflec-
tor are correctly in position
and in good condition: have
them replaced as soon as
they show any signs of
damage.
STARTING
THE LAWNMOWER
Before
motor, ensure that the handle-
bar is locked in position and
the blade is fitted correctly
and tight.
height
your lawnmower is directly
connected to the motor and
rotates as soon as the latter is
switched on. Do not start the
motor when the contact is in
contact with long, uncut grass
as this could cause difficulties
starting. Start the lawnmower
with care, in a clear area.
Always keep your feet away
from the blade. Never tip up
your lawnmower when starting
it, or whilst the blade is rota-
ting. If, however, in particular if
there is not enough clear
space, the lawnmower has to
be tipped up to start the motor
and the blade, press on the
handlebar to raise the front
part, without tipping it more
than necessary (fig. 11).
Starting:
- Stand behind the handlebar
- Press
- Release the button: the motor
starting
the
Stopping:
- To stop the lawnmower,
The The blade on
Safety: The motor in your
lawnmower is fitted with an
electromagnetic brake. This
safety
motor and blade can be stop-
ped very quickly (in less than
3 seconds).
WARNING! Although it is bra-
ked, the blade will continue
to rotate by inertia for a few
seconds when the lawnmower
is stopped.
ready to begin work.
the
start
(1-fig.12) and move the
operating lever towards the
handlebar
(2-fig.12):
motor and the blade will
start at the same time.
will continue to run as long as
you are holding the operating
lever.
release the lever: the motor
and blade will be stopped
and braked.
device
means
button
the
the
Publicidad
Tabla de contenido
