NSK Multi Pad Manual Del Usuario página 14

9–1–3 [3. Lamp] : For setting the function of the LED.
At setup mode, select "Lamp" on the screen. Then you will see the next selection shown below diagram.
3.5V(NLX) / 3.3V(iMD).
sec.
1.Language
2.Gear ratio
3.Lamp On / Off
4.Endo mode Intensity
5.Air Delay timer
6.Endo alert
7.Others
8.Version
NOTICE The setting items of "Intensity" and "Delay timer" will be displayed only when lamp setting is
"On".
9–1–4 [4. Endo mode] : Endo (endodontics) mode setting.
This setting is not applicable to the NLX nano motor.
1.Language
2.Gear ratio
3.Lamp
4.Endo mode
5.Air Display setting
6.Endo alert
7.Others Auto REV time
8.Version Auto FWD time
9–1–5 [5. Air] : Calibration for air driven foot control.
Air pressure may vary on the dental chair unit. The foot control of the Multi Pad system has a feature for
synchronizing the motor speed with the air pressure.
Adjust the air pressure within a range shown below by adjusting foot control. When a message of "under" is
displayed, air pressure is too low. When a message of "over" is displayed, air pressure is too high.
(4.3 – 14.5 psi or 0.30 – 1.00 bar, 0.030 – 0.100MPa).
(29.0 – 58.0 psi or 2.00 – 4.00 bar, 0.200 – 0.400MPa).
1.Language
2.Gear ratio
3.Lamp
4.Endo mode
5.Air Display setting
6.Endo alert
7.Others Motor MIN pressure
8.Version Motor MAX pressure
On / Off Case of iMD
Ncm
Nmm
%
1.0 – 3.0 sec
psi
bar
MPa
13