NSK Multi Pad Manual Del Usuario página 18

Guidance and manufacturer's declaration – electromagnetic immunity
The Multi Pad is intended for use in the electromagnetic environment specified below. The customer or the user of the Multi Pad should assure
that it is used in such an environment.
Immunity test EN/IEC 60601 test level
Conducted RF 3 Vrms
EN 61000-4-6 150 kHz to 80 MHz
IEC 61000-4-6
Radiated RF 3 V/m
EN 61000-4-3 80 MHz to 2.5 GHz
IEC 61000-4-3
NOTE 1 At 80MHz and 800 MHz, the higher frequency range applies.
NOTE 2
objects and people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobiles radios, amateur radio,
AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment
due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the
Multi Pad is used exceeds the applicable RF compliance level above, the Multi Pad should be observed to verity normal operation. If abnormal
performance is observed, additional measures may be necessary, such as reorienting or relocating the Multi Pad.
b
Over the frequency range 150 kHz to 80MHz, field strengths should be less than 3 V/m.
Recommended separation distances between portable and mobile RF communications equipment and the Multi Pad
The Multi Pad is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or
the user of the Multi Pad can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile
RF communications equipment (transmitters) and the product as recommended below, according to the maximum output power of the
communications equipment.
Rated maximum output power of the
transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance in meters (m) can be estimated
using equation applicable to the frequency of the transmitter, where
according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2
objects and people.
Compliance level Electromagnetic environment – guidance
Portable and mobile RF communications equipment should be used no
closer to any part of the Multi Pad, including cables,than the recommended
separation distance calculated from the equation applicable to the frequency
of the transmitter.
Recommended separation distance.
Where is the maximum output power rating of the transmitter in watts
(W) according to the transmitter manufacturer and d is the recommended
separation distance in meters (m).
Field strengths from fixed RF transmitters, as determined by an
electromagnetic site survey
each frequency range
Interference may occur in the vicinity of equipment
3 Vrms d = 1.2
3 V/m d = 1.2 80 MHz to 800 MHz
d = 2.3 800 MHz to 2.5 GHz
Separation distance according to frequency of transmitter
150kHz to 80MHz
d = 1.2
0.12
0.38
1.2
3.8
12
is the maximum output power rating of the transmitter in watts (W)
17
, should be less than the compliance level in
a
b .
80MHz to 800MHz
d = 1.2
0.12
0.38
1.2
3.8
12
800MHz to 2.5GHz
d = 2.3
0.23
0.73
2.3
7.3
23