Makita HKU01 Manual De Instrucciones página 7

012935
Pull up lightly and remove the rubber cap from the slit in
the lower housing as shown in the figure.
NOTE:
Do not pull up the rubber cap forcibly because
•
forcing it may damage its retaining section.
1
2
012931
Bend the cord of the battery converter BCV01 over the
product attachment section. Then run the cord of the
BCV01 through the slit in the lower housing and close
the battery hood.
To remove the BCV01, follow the installation procedure
in reverse.
BCV02 (optional accessory)
012934
Open the battery hood and click in the BCV02 into the
battery port. Close the battery hood.
To remove the BCV02, press on the hook of the BCV02
and withdraw it with both hands.
Indication lamp
WARNING:
Do not use the battery selection switch during the
•
operation.
After flipping the battery selection switch, the main
•
switch is turned off. To start the tool, the operator
1. Rubber cap
1
1. Battery hood
2. Product
mounting
4
adapter of the
BCV01
3. Cord
4. Slit in the lower
housing
3
1. Battery
converter
(BCV02)
1
needs to press the main switch.
4
1. Indication lamps
2. Battery lamp 1
3. Battery lamp 2
4. Warning lamp
5. Battery selection switch
012839
1
1 2
012937
You can switch the battery by flipping the battery
selection switch when the tool is equipped two batteries.
(The indication lamps shows the status No.1 or No.6.)
If the tool is equipped one battery, flip the battery button
to chose one side which the battery is equipped.
If the tool is equipped one battery and you switch
•
to a battery port in which no battery cartridge is
mounted, the indication lamps shows the status
No.2 or No.5.
The warning lamp lights up when a problem occurs, and
the tool is automatically switched off about 10 seconds
after the warning lamp has lighted. The indication of the
warning lamp means as follows.
7
2
3 4 5
3
1
5
2
6