Tools Needed For Assembly And Adjustment - skilsaw SPT99T Instrucciones De Funcionamiento Y Seguridad

Tools Needed for Assembly and Adjustment

Disconnect the plug from the power source before performing any assembly,
WARNING
adjustment or repair to avoid possible injury.
Phillips & Flat Head
Screwdriver
Blade Wrench
(supplied)
1. Position square and
draw a light line
3/4" board with
straight top edge
Adjustable Wrench or
1/2 inch Wrench and
11/16 inch Wrench
5 MM Hex "L" Wrench
COMBINATION SQUARE MUST BE TRUE
drawn line
(supplied)
2. Flip square
(shown in dotted position)
3. Check edge of flipped
square against the drawn line.
There should be no gap or
overlap at the bottom end.
no gap or overlap
-16-
Combination Square