Charging The Monitor; Important; Installation - Little Journey HE161313 Manual Del Usuario

Video Baby Monitor
Test Before Installation
Before installing the Baby Monitor in its final location, check the position and
reception of the camera. First charge the battery for 4-5 hours. Next, one adult
should view the monitor. The other adult should position the camera in the
nursery. Place an object in the crib to simulate the baby's position. If reception
is not clear, slightly reposition the camera to achieve a clear signal.

Installation

1. Installing the PTZ Camera
a. Connect the Power Adaptor to the DC port at the
back of the camera
b. Connect the other end of the power adaptor to
a main power outlet. The LED on the back of the
temperature sensor will illuminate, indicating camera
is on
NOTE: Ensure the PTZ Camera is placed on a flat surface such as a desk or
shelf, out of reach of children
IMPORTANT: Do not place the PTZ Camera or any cords within 3 feet (0.9M)
range of the child's bed

2. Charging the Monitor

a. Connect the micro USB plug Adaptor to the micro
USB port located on the side of the Baby Monitor
b. Connect the other end of the power adaptor to a
main power outlet. The bars on the battery icon
located on the top right corner of the screen will
increase, indicating your monitor is now charging
c. Once the battery is fully charged, unplug the
charging cable from the monitor and remove the adaptor from the
power outlet
NOTE: It is recommended to charge the Baby Monitor for at least 3 hours prior
to first use
IMPORTANT: Only charge the Baby Monitor battery when the battery life
indicator is low. Continuously recharging your battery or leaving the power
adaptor plugged into the Baby Monitor, can decrease the life of the monitor
battery
AFTER SALES SUPPORT
800-372-5715
USA
customercare@balcolifestyle.com
Installation
.
9