Preparing To Work; Electrical Connections; How To Start - Stop The Motor - GGP ITALY SPA SGT 350 Manual De Instrucciones

PREPARING TO WORK / HOW TO START - STOP THE MOTOR

5. PREPARING TO WORK

1. CHECKING THE MACHINE
WARNING!
not plugged into the mains socket.
Before starting work please:
– check that the mains frequency and voltage is
the same as the rating data on the "Identification
Plate" (see chap. 1 - 7.8).
– check that the trigger switch and the safety but-
ton (Only for SGT 600 - T 600 E) should move
freely without forcing and return automatically
and rapidly back to their neutral position;
– (Only for SGT 600 - T 600 E) check that the
trigger switch must remain locked until the
safety button is pressed;
– check that the cooling air vents are not ob-
structed;
– check that the power cable and extension lead
are not damaged;
– check that handgrips and protection devices
are clean and dry, correctly mounted and well
fastened to the machine;
– check that the cutting devices and guards are
not damaged;
– check that the machine is not showing signs of
wear or damage due to knocks or other causes,
and carry out the necessary repairs.

6. HOW TO START - STOP THE MOTOR

STARTING THE MOTOR (Fig. 4)
Before starting the motor:
– Fasten the extension lead (1) to the cable clamp
on the rear handgrip.
– FIRST connect the power cable plug (2) to the
extension lead (3) and THEN plug the extension
lead into the mains socket (4).
To start the motor:
– Hold the machine firmly with both hands.
– SGT 600 - T 600 E: Press the safety button and
then the switch (6).
SGT 350: Press the switch (6).
Make sure the machine is

2. ELECTRICAL CONNECTIONS

DANGER!
are not compatible.
– Always handle and connect electric cables
in dry conditions.
– Keep electric sockets or cables away from
wet and damp areas (e.g. puddles or wet
ground).
The quality of the extension leads must be no less
than H07RN-F or H07VV-F, with a minimum sec-
tion of 1.5 mm and a recommended maximum
length of 30 m.
To avoid overheating, do not keep the extension
lead rolled up during use.
DANGER!
tion of any electrical equipment to the mains
of a building must be installed by a qualified
electrician in conformity with the regulations
in force. Incorrect wiring can cause serious
injury and even death.
NOTE
(
Only for SGT 600 - T 600 E) When you release
the switch, the safety button is also released and
the motor stops.
STOPPING THE MOTOR (Fig. 4)
To stop the motor:
– Release the switch (6).
– FIRST unplug the extension lead (3) from the
mains socket (4) and THEN disconnect the
power cable (2) of the machine from the exten-
sion lead (3).
EN
Electricity and moisture
The permanent connec-
21