Cleaning, Care & Maintenance
Before cleaning, switch off the cabinet and disconnect from the mains.
The cabinet should be kept clean using a mild soap solution. Do not use abrasive cleansers. The plastic parts cannot withstand boiling water
(max. temperature +85 °C).
When regular cleaning is performed, be sure to wipe clean the rubber door
otherwise damage the gasket.
The condenser fan air outlet above the compressor must be free of leaves, paper etc. to ensure normal operation of the cabinet.
The condenser on the back of the cabinet must be regularly cleaned as well. This is best done with a vacuum cleaner and a brush
Routine maintenance
Switch off and disconnect from the power supply before cleaning.
•
Clean the enclosure and interior of the appliance as often as possible.
•
Clean the unit with moist cloth. Never allow the switch, control panel, cable or plug to get wet.
•
Do not use abrasive cleaning agents. These can leave harmful residues. Use only mild soapy water.
•
Clean the door seal with water only.
•
Ensure that no cleaning water penetrates into the electrical components.
•
Must not be cleaned by a water jet.
•
Always wipe dry after cleaning with soft cloth.
•
Take care when cleaning the rear of the appliance.
•
An agent or qualifi ed technician must carry out repairs if required.
•
I
t f
e h
p a
i l p
n a
e c
s i
o t
e b
l
f e
i t
refrigerating compartment and clean thoroughly. Please leave the door open to avoid the development of odor and mildew.
Special maintenance
The instructions given in the following paragraph are for SKILLED PERSON.
Periodic Operations
•
Periodically clean the condenser using suitable tools (vacuum cleaner or soft brushes).
•
Check that the electrical connections are not loose.
•
Check that the thermostat and the sensor are in proper working order.
•
Periodically cleaning the condenser can extend the life of the appliance.
•
Recommend that an agent or qualifi ed technician clean the condenser.
•
The key to the electrical cabinet should be kept out of the reach of children and users.
•
Only use the key to open the lock.
a n
t c
e v i
f
r o
o l
g n
e p
i r
d o
, s
n u
l p
g u
t
gasket to ensure any sticky substances are removed that would
e h
p a
i l p
n a
e c
t f a
r e
a h
i v
g n
u t
n r
d e
13
.
t
e h
s
w
t i
h c
o t
O
F
F
o p
i s
o i t
n, empty the
GB