Care And Maintenance - Acculab ALC Serie Manual De Instrucciones

Care and Maintenance

Repairs
Repair work must be performed by trained service technicians. Any attempt by
untrained persons to perform repairs may lead to hazards for the user.
Cleaning
Disconnect the balance/scale from the AC adapter and unplug any interface
!
cables that are connected to the balance/scale
Make sure that no liquid enters the balance/scale housing
!
Do not use any aggressive cleaning agents (solvents or similar agents)
!
§ Clean the balance/scale using a piece of cloth which has been wet with a mild
detergent (soap)
§ After cleaning, wipe down the balance/scale with a soft, dry cloth
Removing and Cleaning the Weighing Pan:
Lift up and remove the weighing pan together with the pan support by gripping
them from under the shield ring. Make sure that you do not damage the
weighing system in doing so.
Cleaning Stainless Steel Surfaces
Clean all stainless steel parts regularly. Remove the stainless steel weighing
pan/load plate and thoroughly clean it separately. Use a damp cloth or sponge
to clean any stainless steel parts on the balance/scale. You can use any
commercially available household cleaning agent that is suitable for use on
stainless steel. Clean stainless steel surfaces by wiping them down. Then clean
the weighing pan/load plate thoroughly, making sure to remove all residues.
Use a damp cloth or sponge to wipe down any stainless steel parts on the
balance/scale again. Afterwards, allow the balance/scale to dry. If desired,
you can apply oil to the cleaned surfaces as additional protection.
Do not use stainless steel cleaning agents that contain soda lye (caustic),
!
acetic acid, hydrochloric acid, sulfuric acid or citric acid.
The use of scrubbing sponges made of steel wool is not permitted.
Solvents are permitted for use only on stainless steel parts.
23