Weather Trend; Trend Arrow Indicators; Connecting Remote Sensors - Bresser NATIONAL GEOGRAPHIC VA Colour RC Manual De Instrucciones

15 Weather Trend

A weather trend for the next 12 hours is calculated from the measured values and displayed graphic-
ally as follows:
1
Illustration 2: Symbols of the weather trend display
1 Sunny
3 Cloudy
5 Stormy

16 Trend arrow indicators

1
1 Rising
3 Falling
The temperature and humidity trend indicator shows the trends of changes in the forthcoming few
minutes. Arrows indicate a rising, steady or falling trend.

17 Connecting remote sensors

The Weather Station can display the readings from up to 3 wireless sensors* of the same type. Each
radio sensor must be set to a separate channel. Proceed as follows to set the channel:
1. Remove the battery compartment cover of the wireless sensor.
2. Set the channel selection switch to the desired channel (CH1, CH2 or CH3).
3. Re-attach the battery compartment cover.
4. NOTICE! Each connected wireless sensor must be set to a different channel. If only one wire-
less sensor is connected, it should be set to CH1.
5. Press the CHANNEL button on the base station several times to display the measured values for
the individual channels. The selected channel is shown in the display.
6. Press CHANNEL button for about 3 seconds to reset the values and search for a wireless sensor
(RF signal).
*further wireless sensors are optionally available
2 3
2
4 5
2 Partly Cloudy
4 Rainy
6 Snowy
3
2 Steady
6
23 / 48