Publicidad
Idiomas disponibles
Idiomas disponibles
Distances
• Keep the device at least 20 cm away from ceilings or walls.
• Respect a minimum distance of 1 m between the device's light
output and any illuminated surface.
Mounting the lamp
1.
This luminaire does not have a built-in device to disconnect it
from the electric mains. Make sure to electrically isolate the
luminaire before installation or maintenance activities are
performed.
2.
Use the mounting bracket [1] to determine the location of the
mounting holes.
3.
Drill the holes and secure the bracket using screws and wall
plugs.
4.
Connect the power cable to a suitable junction box (not incl.).
Make sure the connection is properly earthed. Make sure there is
no strain on the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by
the manufacturer, his service agent, or a similar qualified person
in order to avoid any hazard.
5.
To point the lamp in the desired direction: loosen the hinges [2]
using a spanner.
6.
Tilt the lamp in the desired angle and tighten the hinges.
7.
Cleaning and maintenance
• All screws should be tight and free of corrosion.
• The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not
be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the
connections...
• Mechanically moving parts must not show any signs of wear and
tear.
• The electric power supply cables must not show any damage.
Have a qualified technician maintain the device.
• If the protective glass [3] is damaged, disconnect the lamp
immediately from the mains. Have it repaired immediately by a
qualified technician. Do not use the lamp with a cracked or broken
protective glass.
V. 01 – 05/09/2012
LEDA301/302/303
6
©Velleman nv
Publicidad
