Activation Of Service Programs; Selecting The Flushing Program - DURAVIT DuraStyle 28043100 Serie Manual De Instrucciones

5.2 Activation of service programs

Refer to page 2 for a graphic illustration of program selection.
S1 - Five minutes no flushing
> Hold the magnetic key in front of the sensor eye until 1 signal tone is sounds.
> Remove the magnetic key
The control confirms the activation of the service program by 2 short signal tones.
Service program S1 is activated.
S2 - Intermittent flushing
> Hold the magnetic key in front of the sensor eye until 2 signal tones sound.
> Remove the magnetic key
The control confirms the activation of the service program by 2 short signal tones.
Service program S2 is activated.
5.3 Selecting the flushing program
Refer to page 2 for a graphic illustration of program selection.
P1: Standard (factory setting/default)
> Hold the magnetic key in front of the sensor eye until 3 signal tones sound.
> Remove the magnetic key
The control confirms the activation of the flushing program by 2 short signal
tones.
Flushing program P1 is activated.
P2: Vario – water efficiency program
> Hold the magnetic key in front of the sensor eye until 4 signal tones sound.
> Remove the magnetic key
The control confirms the activation of the flushing program by 2 short signal
tones.
Flushing program P2 is activated.
27