System Learning, Reset Process, And Led Display - Accessmatic cyborg Panther 1200 Manual De Usuario

1200
Opening your life
C. Memorizing an additional transmitter by a memorized one:
Press and hold A and B buttons for 5 seconds, LED light and external ash light will blink at the same time. Within 10 seconds, press any
button on the un-memorized transmitter for 2 seconds, the transmitter will be memorized after LED light and external ash light are o . To
program by memorized transmitter, just can do the transmitter learning one by one.

4.4 System learning, reset process, and LED display

A. System Learning:
Step1: Press and hold "RF" and "SET" buttons for 3 seconds, the LED display shows "OL" and the motor enters the system learning program.
Step2: Set the open limit and LED shows "OL". Press and hold "UP" or "DOWN" button to adjust the door. When the door is at the proper open
position, press "SET" button.
Step3: Set the close limit and LED shows "CL". Press and hold "UP" or "DOWN" button to adjust the door. When the door is at the proper close
position, press "SET" button.
Step4: When the LED shows "GE". Press "SET" button to proceed operation testing. The LED will show the operation current value in the
process and memorize overcurrent value.
Step5: The motor opens and closes automatically with full speed. The LED shows "SO" while the system learning is completed. Otherwise,
the LED will show "SF" when the system learning is failed. The LED will be o after 10 seconds.
Note: The overcurrent function and ashing light function will be activated automatically after the learning process is completed.
16