System Operation; Daily Inspection; Cleaning And Lubrication - SKYLOTEC Jackpod Davit Instrucciones De Uso

Tabla de contenido

Idiomas disponibles

4.5 System operation

Once all accessories have been properly installed onto the system, accessory operation is as outlined

in the applicable Operator's Manual. Manuals for winches, SRL's, or other accessories provided by

Skylotec GmbH are provided with the equipment at time of purchase. Replacement manuals are available

from Skylotec GmbH or your local dealer. No person shall use this winch without receiving proper training

as outlined in Section 5. Any user must fully read and understand this manual

and any other instruction manual(s) related to the system being used, or have the instructions explained

to them, before using this equipment.

4.6 Inspection

The Jackpod Davit Arm must be inspected before each use as outlined in Section 6.1.

Any problems must be reported immediately to your supervisor, and the equipment labeled to prevent

further use until it has been repaired.

NOTE: Any time a winch is returned to a factory authorized service center for repair, please provide

photocopies of all previous Inspection Log sheets for that winch to assist with diagnosis and processing

of any warranty claims. Please obtain a Returned Goods Authorization number from the service center

before sending your winch for service.

5. TRAINING

Any worker using this Jackpod Davit Arm must receive appropriate training from their employer on all

equipment involved prior to operating. Users must fully read and understand this manual and any other

instruction manual(s) related to the system being used, or have the instructions explained to them, before

using this equipment.

6. INSPECTION

The Jackpod Davit Arm must be inspected before each use as described in Sections 6.1.1 to 6.1.3. Report

any problems or concerns to your supervisor, and do not use the equipment until they have approved

doing so.

If required, clean and lubricate the Jackpod Davit Arm and all its parts as outlined in Section 7. Do not use

solvents or other chemicals to clean the base.

6.1.2 Physical Damage

Inspect the Jackpod Davit System and all accessories for physical damage; bent parts, loose or missing

hardware or parts, and missing, or illegible labels (see Figure 12). Replacement labels are available from

your dealer by ordering the part number shown on each label.

Note: Not all labels shown may be present on your equipment, as some are related to standards and

certifications that may not apply to your jurisdiction.

Tabla de Contenido

Tabla de contenido