Replacing Filters - Shark Rotator Lift-Away Pet ZU570 Serie Manual Del Propietário

EMPTYING THE DUST CUP
IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, lift tabs on both sides
of dust cup handle. Tilt dust cup, then lift
to remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
s h a r kc l e a n . c o m
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow
all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being
drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.

REPLACING FILTERS

Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFFK560
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Filter
Door
CLEAN HEPA FILTER
EVERY YEAR
Press button at bottom of Filter Door. Tilt
filter door and lift out. Remove HEPA Filter.
To reinstall, insert HEPA filter into unit and
replace the filter door.
Replacement
HEPA Filter
XFF5160
s h a r kc l e a n . c o m