Drain Pump Installation (On Some Models) - KitchenAid KUIX535HBS00 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Screw the two hex heads screws back in at the bottom of the
door. For custom door panel, skip this step.
6. Return the ice maker back to upright position.
Reverse Door Catch
1. Remove the white decorative screws from the opposite side
of the door and set aside.
2. Remove the screws from the magnetic door catch and place
them on the opposite side of the door.
3. Install the white decorative screws on the opposite side of the
door.
8
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
4. Plug into a grounded 3 prong outlet.
Drain Pump Installation
(on some models)
NOTES:
Connect drain pump to your drain in accordance with all state
and local codes and ordinances.
It may be desirable to insulate drain tube thoroughly up
to drain inlet to minimize condensation on the drain tube.
Insulated tube kit Part Number W10365792 is available for
purchase.
Drain pump is designed to pump water to a maximum height
of 10 ft (3 m). Use only Whirlpool approved drain pump kit
Part Number 1901A.
Do not connect the outlet end of the drain tube to a closed
pipe system to keep drain water from backing up into the ice
maker.
Kit Contains:
Drain pump kit Part Number 1901A
5/8" I.D. x 5
/
" drain tube (ice maker bin to drain pump
1
8
reservoir inlet)
1/2" I.D. x 10 ft (3 m) drain tube hose (drain pump discharge
to household drain)
5/16" I.D. x 32" (81 cm) vent tube (drain pump reservoir vent
to ice maker cabinet back)
Cable tie (secures vent tube to back of ice maker) (1)
#8-32 x 3/8" pump mounting screws (secures drain pump to
baseplate and clamps to back of ice maker) (5)
5/8" small adjustable hose clamp (secures vent to drain
pump)
7/8" large adjustable hose clamp, (secures drain tube to ice
maker bin and drain pump reservoir inlet) (3)
Rear panel (2)
Instruction sheet

Publicidad

Tabla de contenido
loading

Tabla de contenido